How to install Pu Foam Seals?
Cuishi Rubber
Door Exhibition
1. The Pu Foam seals should not be pulled too tightly. It should be set in place during installation and the surface should be straight.2. A Pu Foam seals is installed at each corner and should be cut into a gap of about 80-85 degrees on the inside,but it cannot be cut short,stick with glue.At right angle also leave about 1mm on the edge.
3. After the Pu Foam seals are installed in the groove at the cut-out, they are pressed and fixed to each other to prevent the joint from being broken when the seals is contracted,